Noise Levels in Fort Campbell, TN | Find Quiet Neighborhoods With Our Sound Map

40 dBA
Average noise across Fort Campbell
Soft rainfall
101
Residents above the EPA 55 dBA threshold
2% of Fort Campbell residents
71 dBA
Loudest residential point
City bus interior

This map shows modeled outdoor noise across Fort Campbell at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Fort Campbell, TN Map of Noise Levels in Fort Campbell
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 101 Fort Campbell residents, or 1.8%, live above that level. By land area, 1.3% of Fort Campbell is above 55 dBA.

See how noise in Fort Campbell compares to similar-sized cities.

Noise by Part of Fort Campbell

Average noise levels for Fort Campbell residents, grouped by direction from the center of Fort Campbell. Eastern Fort Campbell carries the highest population-weighted average; Western Fort Campbell carries the lowest. Just 0% of residents in Western Fort Campbell live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Eastern Fort Campbell.

Central Fort Campbell

38.5 dBA · Quiet
Soft rainfall

0% of people above 55 dBA

QuietLoud

Eastern Fort Campbell

41.9 dBA · Quiet
Quiet suburban street at night

1% of people above 55 dBA

QuietLoud

Northern Fort Campbell

40.5 dBA · Quiet
Soft rainfall

4% of people above 55 dBA

QuietLoud

Southern Fort Campbell

39.7 dBA · Quiet
Soft rainfall

0% of people above 55 dBA

QuietLoud

Western Fort Campbell

25.7 dBA · Quiet
Whisper

0% of people above 55 dBA

QuietLoud

Eastern Fort Campbell sounds about 207% louder than Western Fort Campbell to the human ear, a 16.2 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

How far back from do you need to be?

produces an estimated 71 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
71 dBA
City bus interior
165 ft
57 dBA
Normal conversation an arm’s length away
330 ft
50 dBA
Quiet office
660 ft
42 dBA
Quiet suburban street at night
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 22% of Fort Campbell sits under tree canopy (about average for cities) and roughly 31% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

-->

How Noise Is Distributed Across Fort Campbell

The bar chart below shows the share of Fort Campbell residents in each noise band. About 97% of residents live below the EPA's 55 dBA threshold, and roughly 2% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Fort Campbell Compares

Fort Campbell sits the lowest among the peer group. Below: how Fort Campbell's average outdoor noise and share of residents above the EPA threshold compare with Woodlawn, Adams, Dover, and Pleasant View.

Average noise level (dBA)

Fort Campbell's 39.6 dBA pop-weighted average is the lowest among the peer group. Tennessee as a whole averages 49.2 dBA and the U.S. averages 52.0 dBA. Both are lower than Fort Campbell because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 1.8% of Fort Campbell residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's in the middle of its peer group. Measured by land area instead, 1.3% of Fort Campbell's footprint sits above 55 dBA, against a Tennessee average of 18.7% and a national average of 28.1%.

What This Means if You're Moving to Fort Campbell

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 22% of Fort Campbell is under tree cover (about average for cities), and the dominant land cover is low-intensity developed land. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.