Noise Levels in Lake Hubert, MN | Find Quiet Neighborhoods With Our Sound Map

45 dBA
Average noise across Lake Hubert
Quiet suburban street at night
77
Residents above the EPA 55 dBA threshold
6% of Lake Hubert residents
69 dBA
Loudest residential point
Highway traffic 50 ft away

This map shows modeled outdoor noise across Lake Hubert at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Lake Hubert, MN Map of Noise Levels in Lake Hubert
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 77 Lake Hubert residents, or 5.9%, live above that level. By land area, 3.9% of Lake Hubert is above 55 dBA.

See how noise in Lake Hubert compares to similar-sized cities.

Noise by Part of Lake Hubert

Average noise levels for Lake Hubert residents, grouped by direction from the center of Lake Hubert. Eastern Lake Hubert carries the highest population-weighted average; Northern Lake Hubert carries the lowest. Just 3% of residents in Northern Lake Hubert live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Eastern Lake Hubert.

Eastern Lake Hubert

49.3 dBA · Mostly quiet
Quiet office

19% of people above 55 dBA

QuietLoud

Northern Lake Hubert

41.5 dBA · Quiet
Quiet suburban street at night

3% of people above 55 dBA

QuietLoud

Southern Lake Hubert

48.8 dBA · Mostly quiet
Quiet office

8% of people above 55 dBA

QuietLoud

Eastern Lake Hubert sounds about 72% louder than Northern Lake Hubert to the human ear, a 7.8 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

Loudest Road Corridors

The model evaluates every road in Lake Hubert using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance, faster in vegetated areas and slower over open pavement.

RoadTypeAvg. source dBAPeak source dBA
Mollie Lake Rd Local 55.0 55
Red Oak Rd Local 55.0 55
Garden View Rd Local 55.0 55
N Long Lake Rd Local 55.0 55

How far back from Mollie Lake Rd do you need to be?

Mollie Lake Rd produces an estimated 55 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
55 dBA
Quiet office to normal conversation
165 ft
42 dBA
Quiet suburban street at night
330 ft
35 dBA
Soft rainfall
660 ft
35 dBA
Soft rainfall
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 44% of Lake Hubert sits under tree canopy (heavier than most cities) and roughly 0% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

How Noise Is Distributed Across Lake Hubert

The bar chart below shows the share of Lake Hubert residents in each noise band. About 100% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Lake Hubert Compares

Lake Hubert sits the lowest among the peer group. Below: how Lake Hubert's average outdoor noise and share of residents above the EPA threshold compare with Lake Shore, Riverton, Ironton, and Merrifield.

Average noise level (dBA)

Lake Hubert's 45.3 dBA pop-weighted average is the lowest among the peer group. Minnesota as a whole averages 53.6 dBA and the U.S. averages 52.0 dBA. Both are lower than Lake Hubert because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 5.9% of Lake Hubert residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's fewer than any of its peer group. Measured by land area instead, 3.9% of Lake Hubert's footprint sits above 55 dBA, against a Minnesota average of 31.0% and a national average of 28.1%.

What This Means if You're Moving to Lake Hubert

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from Mollie Lake Rd and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 44% of Lake Hubert is under tree cover (heavier than most cities), and the dominant land cover is woody wetlands. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.