Noise Levels in Lohman, MO | Find Quiet Neighborhoods With Our Sound Map

48 dBA
Average noise across Lohman
Quiet office
161
Residents above the EPA 55 dBA threshold
9% of Lohman residents
64 dBA
Loudest residential point
Busy restaurant

This map shows modeled outdoor noise across Lohman at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Lohman, MO Map of Noise Levels in Lohman
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 161 Lohman residents, or 9.4%, live above that level. By land area, 10.8% of Lohman is above 55 dBA.

See how noise in Lohman compares to similar-sized cities.

Noise by Part of Lohman

Average noise levels for Lohman residents, grouped by direction from the center of Lohman. Eastern Lohman carries the highest population-weighted average; Northern Lohman carries the lowest. Just 4% of residents in Northern Lohman live in blocks above the EPA's 55 dBA threshold, a third of the share in Eastern Lohman.

Eastern Lohman

49.0 dBA · Mostly quiet
Quiet office

13% of people above 55 dBA

QuietLoud

Northern Lohman

43.9 dBA · Quiet
Quiet suburban street at night

4% of people above 55 dBA

QuietLoud

Southern Lohman

45.6 dBA · Mostly quiet
Quiet suburban street at night

9% of people above 55 dBA

QuietLoud

Western Lohman

47.0 dBA · Mostly quiet
Quiet office

6% of people above 55 dBA

QuietLoud

Eastern Lohman sounds about 42% louder than Northern Lohman to the human ear, a 5.1 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

Loudest Road Corridors

The model evaluates every road in Lohman using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance, faster in vegetated areas and slower over open pavement.

RoadTypeAvg. source dBAPeak source dBA
C Minor arterial 57.9 58
D Local 55.3 56
Mt Hope Rd Local 55.0 55
Rockhouse Rd Local 55.0 55
Dynamite Ridge Local 55.0 55

How far back from C do you need to be?

C produces an estimated 58 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
58 dBA
Normal conversation an arm’s length away
165 ft
46 dBA
Quiet suburban street at night
330 ft
39 dBA
Soft rainfall
660 ft
35 dBA
Soft rainfall
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 40% of Lohman sits under tree canopy (about average for cities) and roughly 1% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

How Noise Is Distributed Across Lohman

The bar chart below shows the share of Lohman residents in each noise band. About 97% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Lohman Compares

Lohman sits at the quieter end of the spectrum. Below: how Lohman's average outdoor noise and share of residents above the EPA threshold compare with St. Martins, Wardsville, Centertown, and Russellville.

Average noise level (dBA)

Lohman's 47.5 dBA pop-weighted average is at the quieter end of the spectrum. Missouri as a whole averages 53.9 dBA and the U.S. averages 52.0 dBA. Both are lower than Lohman because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 9.4% of Lohman residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's in the middle of its peer group. Measured by land area instead, 10.8% of Lohman's footprint sits above 55 dBA, against a Missouri average of 32.5% and a national average of 28.1%.

What This Means if You're Moving to Lohman

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from C and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 40% of Lohman is under tree cover (about average for cities), and the dominant land cover is deciduous forest. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.