Noise Levels in Lost Creek, WA | Find Quiet Neighborhoods With Our Sound Map

37 dBA
Average noise across Lost Creek
Soft rainfall
1
Residents above the EPA 55 dBA threshold
1% of Lost Creek residents
56 dBA
Loudest residential point
Quiet office to normal conversation

This map shows modeled outdoor noise across Lost Creek at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Lost Creek, WA Map of Noise Levels in Lost Creek
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 1 Lost Creek residents, or 0.6%, live above that level. By land area, 0.4% of Lost Creek is above 55 dBA.

See how noise in Lost Creek compares to similar-sized cities.

Noise by Part of Lost Creek

Average noise levels for Lost Creek residents, grouped by direction from the center of Lost Creek. Eastern Lost Creek carries the highest population-weighted average; Southern Lost Creek carries the lowest. Just 0% of residents in Southern Lost Creek live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Eastern Lost Creek.

Eastern Lost Creek

41.8 dBA · Quiet
Quiet suburban street at night

1% of people above 55 dBA

QuietLoud

Northern Lost Creek

35.3 dBA · Quiet
Soft rainfall

0% of people above 55 dBA

QuietLoud

Southern Lost Creek

25.0 dBA · Quiet
Whisper

0% of people above 55 dBA

QuietLoud

Western Lost Creek

37.0 dBA · Quiet
Soft rainfall

0% of people above 55 dBA

QuietLoud

Eastern Lost Creek sounds about 220% louder than Southern Lost Creek to the human ear, a 16.8 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

Loudest Road Corridors

The model evaluates every road in Lost Creek using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance, faster in vegetated areas and slower over open pavement.

RoadTypeAvg. source dBAPeak source dBA
Black Rd Local 55.0 55
Bennett Rd Local 55.0 55
Bartlette Rd Local 55.0 55
Westside Calispell Rd Local 55.0 55
Jared Rd Local 55.0 55

How far back from Black Rd do you need to be?

Black Rd produces an estimated 55 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
55 dBA
Quiet office to normal conversation
165 ft
41 dBA
Quiet suburban street at night
330 ft
35 dBA
Soft rainfall
660 ft
35 dBA
Soft rainfall
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 33% of Lost Creek sits under tree canopy (about average for cities) and roughly 1% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

How Noise Is Distributed Across Lost Creek

The bar chart below shows the share of Lost Creek residents in each noise band. About 100% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Lost Creek Compares

Lost Creek sits at the louder end of the spectrum. Below: how Lost Creek's average outdoor noise and share of residents above the EPA threshold compare with Locke, Ruby, Tiger, and Jared.

Average noise level (dBA)

Lost Creek's 37.4 dBA pop-weighted average is at the louder end of the spectrum. Washington as a whole averages 51.3 dBA and the U.S. averages 52.0 dBA. Both are lower than Lost Creek because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 0.6% of Lost Creek residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's more than any of its peer group. Measured by land area instead, 0.4% of Lost Creek's footprint sits above 55 dBA, against a Washington average of 27.7% and a national average of 28.1%.

What This Means if You're Moving to Lost Creek

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from Black Rd and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 33% of Lost Creek is under tree cover (about average for cities), and the dominant land cover is evergreen forest. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.