Noise Levels in Old Washington, OH | Find Quiet Neighborhoods With Our Sound Map

50 dBA
Average noise across Old Washington
Quiet office
54
Residents above the EPA 55 dBA threshold
17% of Old Washington residents
77 dBA
Loudest residential point
City bus interior

This map shows modeled outdoor noise across Old Washington at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Old Washington, OH Map of Noise Levels in Old Washington
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 54 Old Washington residents, or 17.2%, live above that level. By land area, 55.1% of Old Washington is above 55 dBA.

See how noise in Old Washington compares to similar-sized cities.

Noise by Part of Old Washington

Average noise levels for Old Washington residents, grouped by direction from the center of Old Washington. Central Old Washington carries the highest population-weighted average; Southern Old Washington carries the lowest. Just 2% of residents in Southern Old Washington live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Central Old Washington.

Central Old Washington

68.9 dBA · Loud
Highway traffic 50 ft away

81% of people above 55 dBA

QuietLoud

Eastern Old Washington

55.1 dBA · Moderate-loud
Quiet office to normal conversation

100% of people above 55 dBA

QuietLoud

Northern Old Washington

49.0 dBA · Mostly quiet
Quiet office

19% of people above 55 dBA

QuietLoud

Southern Old Washington

45.1 dBA · Mostly quiet
Quiet suburban street at night

2% of people above 55 dBA

QuietLoud

Western Old Washington

55.2 dBA · Moderate-loud
Quiet office to normal conversation

22% of people above 55 dBA

QuietLoud

Central Old Washington sounds about 421% louder than Southern Old Washington to the human ear, a 23.8 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

How far back from Ir 70 do you need to be?

Ir 70 produces an estimated 75 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a quiet suburban street at night.

At source
75 dBA
City bus interior
165 ft
64 dBA
Busy restaurant
330 ft
57 dBA
Normal conversation an arm’s length away
660 ft
51 dBA
Quiet office
¼ mile
44 dBA
Quiet suburban street at night
½ mile
37 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 34% of Old Washington sits under tree canopy (about average for cities) and roughly 12% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

-->

How Noise Is Distributed Across Old Washington

The bar chart below shows the share of Old Washington residents in each noise band. About 78% of residents live below the EPA's 55 dBA threshold, and roughly 8% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Old Washington Compares

Old Washington sits at the louder end of the spectrum. Below: how Old Washington's average outdoor noise and share of residents above the EPA threshold compare with Highlandtown, Winterset, Kipling, and Buffalo.

Average noise level (dBA)

Old Washington's 49.5 dBA pop-weighted average is at the louder end of the spectrum. Ohio as a whole averages 51.1 dBA and the U.S. averages 52.0 dBA. Both are lower than Old Washington because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 17.2% of Old Washington residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's in the middle of its peer group. Measured by land area instead, 55.1% of Old Washington's footprint sits above 55 dBA, against a Ohio average of 26.4% and a national average of 28.1%.

What This Means if You're Moving to Old Washington

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from Ir 70 and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 34% of Old Washington is under tree cover (about average for cities), and the dominant land cover is deciduous forest. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.