Noise Levels in Shelburne Falls, VT | Find Quiet Neighborhoods With Our Sound Map
42 dBA
Average noise across Shelburne Falls
Quiet suburban street at night
2
Residents above the EPA 55 dBA threshold
1% of Shelburne Falls residents
62 dBA
Loudest residential point
Busy restaurant
This map shows modeled outdoor noise across Shelburne Falls at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.
Overall
Road
Rail
Aviation
Click the map to explore
35 dBa55 dBa (EPA limit)90+ dBa
3545557090
Quietest (dBA)Loudest
Colorblind friendlyoff
What the numbers sound like
30 dBAWhisper
40 dBASoft rainfall
45 dBAQuiet suburban street at night
50 dBAQuiet office
55 dBAEPA outdoor threshold: light traffic 100 ft away
60 dBANormal conversation an arm's length away
65 dBABusy restaurant
70 dBAHighway traffic 50 ft away
80 dBACity bus interior
Population Above the EPA Outdoor Threshold
The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 2 Shelburne Falls residents, or 1.0%, live above that level. By land area, 0.6% of Shelburne Falls is above 55 dBA.
Average noise levels for Shelburne Falls residents, grouped by direction from the center of Shelburne Falls. Western Shelburne Falls carries the highest population-weighted average; Northern Shelburne Falls carries the lowest. Just 0% of residents in Northern Shelburne Falls live in blocks above the EPA's 55 dBA threshold, a fraction of the share in Western Shelburne Falls.
Eastern Shelburne Falls
43.8 dBA · Quiet
Quiet suburban street at night
2% of people above 55 dBA
QuietLoud
Northern Shelburne Falls
35.0 dBA · Quiet
Soft rainfall
0% of people above 55 dBA
QuietLoud
Southern Shelburne Falls
42.9 dBA · Quiet
Quiet suburban street at night
1% of people above 55 dBA
QuietLoud
Western Shelburne Falls
46.2 dBA · Mostly quiet
Quiet office
0% of people above 55 dBA
QuietLoud
Western Shelburne Falls sounds about 117% louder than Northern Shelburne Falls to the human ear, a 11.2 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.
How far back from do you need to be?
produces an estimated 62 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.
At source
62 dBA
Busy restaurant
165 ft
47 dBA
Quiet office
330 ft
38 dBA
Soft rainfall
660 ft
35 dBA
Soft rainfall
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall
Calculated from the model's calibrated attenuation formula. About 58% of Shelburne Falls sits under tree canopy (heavier than most cities) and roughly 0% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.
-->
Airport Noise
Patrick Leahy Burlington International (BTV) sits north of Shelburne Falls. The U.S. Department of Transportation models aviation noise around this airport from federal traffic data, and the model uses those federal measurements rather than synthetic predictions.
Blocks under the approach and departure paths carry combined road-plus-aviation noise, with some exceeding 55 dBA on the map's Overall layer. Blocks on the opposite side of Shelburne Falls, particularly to the south, show no measurable aviation contribution. Use the Aviation toggle on the map above to isolate the airport's footprint.
How Noise Is Distributed Across Shelburne Falls
The bar chart below shows the share of Shelburne Falls residents in each noise band. About 100% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.
How Shelburne Falls Compares
Shelburne Falls sits at the louder end of the spectrum. Below: how Shelburne Falls's average outdoor noise and share of residents above the EPA threshold compare with Prindle Corner, Underhill Center, Monkton Boro, and North Ferrisburg.
Average noise level (dBA)
Shelburne Falls's 42.2 dBA pop-weighted average is at the louder end of the spectrum. Vermont as a whole averages 46.5 dBA and the U.S. averages 52.0 dBA. Both are lower than Shelburne Falls because most of either area is rural land away from major roads.
Share of residents above 55 dBA
About 1.0% of Shelburne Falls residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's more than any of its peer group. Measured by land area instead, 0.6% of Shelburne Falls's footprint sits above 55 dBA, against a Vermont average of 12.4% and a national average of 28.1%.
What This Means if You're Moving to Shelburne Falls
Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
Tree canopy can help reduce modeled noise exposure. Roughly 58% of Shelburne Falls is under tree cover (heavier than most cities), and the dominant land cover is deciduous forest. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.
Airport noise is directional. Patrick Leahy Burlington International's approach paths concentrate aviation noise to the north. Neighborhoods to the south of downtown show no measurable contribution from the airport.
Sources & Methodology
The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.
All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.
