Noise Levels in Stafford, CA | Find Quiet Neighborhoods With Our Sound Map

40 dBA
Average noise across Stafford
Soft rainfall
6
Residents above the EPA 55 dBA threshold
7% of Stafford residents
72 dBA
Loudest residential point
City bus interior

This map shows modeled outdoor noise across Stafford at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Stafford, CA Map of Noise Levels in Stafford
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 6 Stafford residents, or 7.4%, live above that level. By land area, 18.1% of Stafford is above 55 dBA.

See how noise in Stafford compares to similar-sized cities.

Noise by Part of Stafford

Average noise levels for Stafford residents, grouped by direction from the center of Stafford. Southern Stafford carries the highest population-weighted average; Western Stafford carries the lowest. Just 0% of residents in Western Stafford live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Southern Stafford.

Northern Stafford

23.0 dBA · Quiet
Whisper

0% of people above 55 dBA

QuietLoud

Southern Stafford

50.4 dBA · Moderate
Quiet office

12% of people above 55 dBA

QuietLoud

Western Stafford

12.4 dBA · Quiet
Whisper

0% of people above 55 dBA

QuietLoud

Southern Stafford sounds about 1293% louder than Western Stafford to the human ear, a 38.0 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

How far back from do you need to be?

produces an estimated 72 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
72 dBA
City bus interior
165 ft
58 dBA
Normal conversation an arm’s length away
330 ft
50 dBA
Quiet office
660 ft
42 dBA
Quiet suburban street at night
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 34% of Stafford sits under tree canopy (about average for cities) and roughly 0% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

-->

How Noise Is Distributed Across Stafford

The bar chart below shows the share of Stafford residents in each noise band. About 53% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Stafford Compares

Stafford sits the highest among the peer group. Below: how Stafford's average outdoor noise and share of residents above the EPA threshold compare with Shively, McCann, Dinsmore, and Whitlow.

Average noise level (dBA)

Stafford's 40.3 dBA pop-weighted average is the highest among the peer group. California as a whole averages 54.0 dBA and the U.S. averages 52.0 dBA. Both are lower than Stafford because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 7.4% of Stafford residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's more than any of its peer group. Measured by land area instead, 18.1% of Stafford's footprint sits above 55 dBA, against a California average of 36.0% and a national average of 28.1%.

What This Means if You're Moving to Stafford

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 34% of Stafford is under tree cover (about average for cities), and the dominant land cover is evergreen forest. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.