Noise Levels in Sugarcreek, PA | Find Quiet Neighborhoods With Our Sound Map

47 dBA
Average noise across Sugarcreek
Quiet office
786
Residents above the EPA 55 dBA threshold
18% of Sugarcreek residents
68 dBA
Loudest residential point
Highway traffic 50 ft away

This map shows modeled outdoor noise across Sugarcreek at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Sugarcreek, PA Map of Noise Levels in Sugarcreek
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 786 Sugarcreek residents, or 18.2%, live above that level. By land area, 18.1% of Sugarcreek is above 55 dBA.

See how noise in Sugarcreek compares to similar-sized cities.

Noise by Part of Sugarcreek

Average noise levels for Sugarcreek residents, grouped by direction from the center of Sugarcreek. Southern Sugarcreek carries the highest population-weighted average; Eastern Sugarcreek carries the lowest. Just 10% of residents in Eastern Sugarcreek live in blocks above the EPA's 55 dBA threshold, a third of the share in Southern Sugarcreek.

Eastern Sugarcreek

40.4 dBA · Quiet
Soft rainfall

10% of people above 55 dBA

QuietLoud

Northern Sugarcreek

42.3 dBA · Quiet
Quiet suburban street at night

2% of people above 55 dBA

QuietLoud

Southern Sugarcreek

53.6 dBA · Moderate-loud
Quiet office to normal conversation

34% of people above 55 dBA

QuietLoud

Western Sugarcreek

42.8 dBA · Quiet
Quiet suburban street at night

4% of people above 55 dBA

QuietLoud

Southern Sugarcreek sounds about 150% louder than Eastern Sugarcreek to the human ear, a 13.2 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

Loudest Road Corridors

The model evaluates every road in Sugarcreek using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance, faster in vegetated areas and slower over open pavement.

RoadTypeAvg. source dBAPeak source dBA
Allegheny BL Principal arterial 61.4 64
Twentyeighth Division Hw Principal arterial 60.2 61
Rocky Grove Av Minor arterial 54.8 58
Efuk Warren Rd Local 57.0 57
Efth Mccleery Rd Local 57.0 57

How far back from Allegheny BL do you need to be?

Allegheny BL produces an estimated 64 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
64 dBA
Busy restaurant
165 ft
53 dBA
Quiet office to normal conversation
330 ft
47 dBA
Quiet office
660 ft
40 dBA
Soft rainfall
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 46% of Sugarcreek sits under tree canopy (heavier than most cities) and roughly 11% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

How Noise Is Distributed Across Sugarcreek

The bar chart below shows the share of Sugarcreek residents in each noise band. About 80% of residents live below the EPA's 55 dBA threshold, and roughly 1% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Sugarcreek Compares

Sugarcreek sits at the quieter end of the spectrum. Below: how Sugarcreek's average outdoor noise and share of residents above the EPA threshold compare with Franklin, Cochranton, Knox, and Seneca.

Average noise level (dBA)

Sugarcreek's 47.3 dBA pop-weighted average is at the quieter end of the spectrum. Pennsylvania as a whole averages 52.9 dBA and the U.S. averages 52.0 dBA. Both are lower than Sugarcreek because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 18.2% of Sugarcreek residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's in the middle of its peer group. Measured by land area instead, 18.1% of Sugarcreek's footprint sits above 55 dBA, against a Pennsylvania average of 33.5% and a national average of 28.1%.

What This Means if You're Moving to Sugarcreek

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from Allegheny BL and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 46% of Sugarcreek is under tree cover (heavier than most cities), and the dominant land cover is deciduous forest. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.