This map shows modeled outdoor noise across Villalba Municipio at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.
What the numbers sound like
- 30 dBAWhisper
- 40 dBASoft rainfall
- 45 dBAQuiet suburban street at night
- 50 dBAQuiet office
- 55 dBAEPA outdoor threshold: light traffic 100 ft away
- 60 dBANormal conversation an arm's length away
- 65 dBABusy restaurant
- 70 dBAHighway traffic 50 ft away
- 80 dBACity bus interior
Population Above the EPA Outdoor Threshold
The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 4,255 Villalba Municipio residents, or 21.3%, live above that level. By land area, 23.0% of Villalba Municipio is above 55 dBA.
See how noise in Villalba Municipio compares to similar-sized counties.
Noise by Part of Villalba Municipio
Average noise levels for Villalba Municipio residents, grouped by direction from the center of Villalba Municipio. Western Villalba Municipio carries the highest population-weighted average; Eastern Villalba Municipio carries the lowest. Just 11% of residents in Eastern Villalba Municipio live in blocks above the EPA's 55 dBA threshold, about half the share in Western Villalba Municipio.
Central Villalba Municipio
18% of people above 55 dBA
Eastern Villalba Municipio
11% of people above 55 dBA
Northern Villalba Municipio
25% of people above 55 dBA
Southern Villalba Municipio
21% of people above 55 dBA
Western Villalba Municipio
26% of people above 55 dBA
Western Villalba Municipio sounds about 23% louder than Eastern Villalba Municipio to the human ear, a 3.0 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.
Loudest Road Corridors
The model evaluates every road in Villalba Municipio using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance, faster in vegetated areas and slower over open pavement.
How far back from Pr-149 do you need to be?
Pr-149 produces an estimated 66 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.
Calculated from the model's calibrated attenuation formula. About 0% of Villalba Municipio sits under tree canopy (about average for counties) and roughly 0% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.
How Noise Is Distributed Across Villalba Municipio
The bar chart below shows the share of Villalba Municipio residents in each noise band. About 81% of residents live below the EPA's 55 dBA threshold, and roughly 3% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.
How Villalba Municipio Compares
Villalba Municipio sits at the quieter end of the spectrum. Below: how Villalba Municipio's average outdoor noise and share of residents above the EPA threshold compare with Orocovis Municipio, Santa Isabel Municipio, Aibonito Municipio, and Ciales Municipio.
Average noise level (dBA)
Villalba Municipio's 50.3 dBA pop-weighted average is at the quieter end of the spectrum. Puerto Rico as a whole averages 52.9 dBA and the U.S. averages 52.0 dBA. Both are lower than Villalba Municipio because most of either area is rural land away from major roads.
Share of residents above 55 dBA
About 21.3% of Villalba Municipio residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's in the middle of its peer group. Measured by land area instead, 23.0% of Villalba Municipio's footprint sits above 55 dBA, against a Puerto Rico average of 36.1% and a national average of 28.1%.
What This Means if You're Moving to Villalba Municipio
- Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from Pr-149 and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
- Tree canopy can help reduce modeled noise exposure. Roughly 0% of Villalba Municipio is under tree cover (about average for counties), and the dominant land cover is . Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.
Sources & Methodology
The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.
Federal datasets used:
FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level
All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.