Noise Levels in Cartwright, OK | Find Quiet Neighborhoods With Our Sound Map

48 dBA
Average noise across Cartwright
Quiet office
202
Residents above the EPA 55 dBA threshold
17% of Cartwright residents
62 dBA
Loudest residential point
Busy restaurant

This map shows modeled outdoor noise across Cartwright at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Cartwright, OK Map of Noise Levels in Cartwright
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 202 Cartwright residents, or 17.0%, live above that level. By land area, 30.9% of Cartwright is above 55 dBA.

See how noise in Cartwright compares to similar-sized cities.

Noise by Part of Cartwright

Average noise levels for Cartwright residents, grouped by direction from the center of Cartwright. Northern Cartwright carries the highest population-weighted average; Eastern Cartwright carries the lowest. Just 0% of residents in Eastern Cartwright live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Northern Cartwright.

Central Cartwright

43.6 dBA · Quiet
Quiet suburban street at night

1% of people above 55 dBA

QuietLoud

Eastern Cartwright

41.7 dBA · Quiet
Quiet suburban street at night

0% of people above 55 dBA

QuietLoud

Northern Cartwright

50.6 dBA · Moderate
Quiet office

23% of people above 55 dBA

QuietLoud

Southern Cartwright

45.8 dBA · Mostly quiet
Quiet suburban street at night

16% of people above 55 dBA

QuietLoud

Western Cartwright

48.8 dBA · Mostly quiet
Quiet office

18% of people above 55 dBA

QuietLoud

Northern Cartwright sounds about 85% louder than Eastern Cartwright to the human ear, a 8.9 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

Loudest Road Corridors

The model evaluates every road in Cartwright using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance, faster in vegetated areas and slower over open pavement.

RoadTypeAvg. source dBAPeak source dBA
Sand Creek Rd Local 53.1 55
Red River City Rd Local 55.0 55
Willafa Woods Rd Major collector 53.6 55
Boat Club Rd Local 54.8 55
N36076 Local 55.0 55

How far back from Sand Creek Rd do you need to be?

Sand Creek Rd produces an estimated 55 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
55 dBA
Quiet office to normal conversation
165 ft
43 dBA
Quiet suburban street at night
330 ft
37 dBA
Soft rainfall
660 ft
35 dBA
Soft rainfall
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 20% of Cartwright sits under tree canopy (lighter than most cities) and roughly 12% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

How Noise Is Distributed Across Cartwright

The bar chart below shows the share of Cartwright residents in each noise band. About 85% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Cartwright Compares

Cartwright sits at the louder end of the spectrum. Below: how Cartwright's average outdoor noise and share of residents above the EPA threshold compare with Silo, Colbert, Willis, and Old Allison.

Average noise level (dBA)

Cartwright's 47.7 dBA pop-weighted average is at the louder end of the spectrum. Oklahoma as a whole averages 50.5 dBA and the U.S. averages 52.0 dBA. Both are lower than Cartwright because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 17.0% of Cartwright residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's more than any of its peer group. Measured by land area instead, 30.9% of Cartwright's footprint sits above 55 dBA, against a Oklahoma average of 22.7% and a national average of 28.1%.

What This Means if You're Moving to Cartwright

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from Sand Creek Rd and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 20% of Cartwright is under tree cover (lighter than most cities), and the dominant land cover is deciduous forest. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.