Noise Levels in Eureka, MI | Find Quiet Neighborhoods With Our Sound Map

41 dBA
Average noise across Eureka
Soft rainfall
43
Residents above the EPA 55 dBA threshold
2% of Eureka residents
76 dBA
Loudest residential point
City bus interior

This map shows modeled outdoor noise across Eureka at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Eureka, MI Map of Noise Levels in Eureka
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 43 Eureka residents, or 2.2%, live above that level. By land area, 1.7% of Eureka is above 55 dBA.

See how noise in Eureka compares to similar-sized cities.

Noise by Part of Eureka

Average noise levels for Eureka residents, grouped by direction from the center of Eureka. Northern Eureka carries the highest population-weighted average; Southern Eureka carries the lowest. Just 0% of residents in Southern Eureka live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Northern Eureka.

Eastern Eureka

43.9 dBA · Quiet
Quiet suburban street at night

6% of people above 55 dBA

QuietLoud

Northern Eureka

44.1 dBA · Quiet
Quiet suburban street at night

0% of people above 55 dBA

QuietLoud

Southern Eureka

37.9 dBA · Quiet
Soft rainfall

0% of people above 55 dBA

QuietLoud

Western Eureka

38.6 dBA · Quiet
Soft rainfall

0% of people above 55 dBA

QuietLoud

Northern Eureka sounds about 54% louder than Southern Eureka to the human ear, a 6.2 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

Loudest Road Corridors

The model evaluates every road in Eureka using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance, faster in vegetated areas and slower over open pavement.

RoadTypeAvg. source dBAPeak source dBA
N Us-127 Freeway 72.8 73
US Hwy 127 Freeway 61.1 66
W Price Rd Major collector 53.7 54
W Jason Rd Local 52.0 52
Loomis Rd Local 52.0 52

How far back from N Us-127 do you need to be?

N Us-127 produces an estimated 73 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
73 dBA
City bus interior
165 ft
59 dBA
Normal conversation an arm’s length away
330 ft
51 dBA
Quiet office
660 ft
43 dBA
Quiet suburban street at night
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 34% of Eureka sits under tree canopy (about average for cities) and roughly 1% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

How Noise Is Distributed Across Eureka

The bar chart below shows the share of Eureka residents in each noise band. About 94% of residents live below the EPA's 55 dBA threshold, and roughly 6% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Eureka Compares

Eureka sits at the quieter end of the spectrum. Below: how Eureka's average outdoor noise and share of residents above the EPA threshold compare with Shepardsville, Fowler, Westphalia, and Perrinton.

Average noise level (dBA)

Eureka's 40.9 dBA pop-weighted average is at the quieter end of the spectrum. Michigan as a whole averages 49.3 dBA and the U.S. averages 52.0 dBA. Both are lower than Eureka because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 2.2% of Eureka residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's in the middle of its peer group. Measured by land area instead, 1.7% of Eureka's footprint sits above 55 dBA, against a Michigan average of 19.9% and a national average of 28.1%.

What This Means if You're Moving to Eureka

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from N Us-127 and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 34% of Eureka is under tree cover (about average for cities), and the dominant land cover is cultivated cropland. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.