Noise Levels in Rose Bud, AR | Find Quiet Neighborhoods With Our Sound Map

46 dBA
Average noise across Rose Bud
Quiet office
163
Residents above the EPA 55 dBA threshold
7% of Rose Bud residents
65 dBA
Loudest residential point
Busy restaurant

This map shows modeled outdoor noise across Rose Bud at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Rose Bud, AR Map of Noise Levels in Rose Bud
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 163 Rose Bud residents, or 7.0%, live above that level. By land area, 10.0% of Rose Bud is above 55 dBA.

See how noise in Rose Bud compares to similar-sized cities.

Noise by Part of Rose Bud

Average noise levels for Rose Bud residents, grouped by direction from the center of Rose Bud. Southern Rose Bud carries the highest population-weighted average; Eastern Rose Bud carries the lowest. Just 4% of residents in Eastern Rose Bud live in blocks above the EPA's 55 dBA threshold, about half the share in Southern Rose Bud.

Eastern Rose Bud

45.0 dBA · Mostly quiet
Quiet suburban street at night

4% of people above 55 dBA

QuietLoud

Northern Rose Bud

46.7 dBA · Mostly quiet
Quiet office

6% of people above 55 dBA

QuietLoud

Southern Rose Bud

47.8 dBA · Mostly quiet
Quiet office

8% of people above 55 dBA

QuietLoud

Western Rose Bud

46.3 dBA · Mostly quiet
Quiet office

10% of people above 55 dBA

QuietLoud

Southern Rose Bud sounds about 21% louder than Eastern Rose Bud to the human ear, a 2.8 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

Loudest Road Corridors

The model evaluates every road in Rose Bud using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance, faster in vegetated areas and slower over open pavement.

RoadTypeAvg. source dBAPeak source dBA
Cahollandrd Local 59.0 59
Brierbranchrd Local 59.0 59
Beckettmtnrd Local 59.0 59
Oldspringfieldrd Local 59.0 59
Pinoakdrw Local 59.0 59

How far back from Cahollandrd do you need to be?

Cahollandrd produces an estimated 59 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
59 dBA
Normal conversation an arm’s length away
165 ft
47 dBA
Quiet office
330 ft
40 dBA
Soft rainfall
660 ft
35 dBA
Soft rainfall
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 36% of Rose Bud sits under tree canopy (about average for cities) and roughly 0% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

How Noise Is Distributed Across Rose Bud

The bar chart below shows the share of Rose Bud residents in each noise band. About 97% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Rose Bud Compares

Rose Bud sits the lowest among the peer group. Below: how Rose Bud's average outdoor noise and share of residents above the EPA threshold compare with Romance, Quitman, Pangburn, and McRae.

Average noise level (dBA)

Rose Bud's 46.5 dBA pop-weighted average is the lowest among the peer group. Arkansas as a whole averages 52.6 dBA and the U.S. averages 52.0 dBA. Both are lower than Rose Bud because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 7.0% of Rose Bud residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's fewer than any of its peer group. Measured by land area instead, 10.0% of Rose Bud's footprint sits above 55 dBA, against a Arkansas average of 29.9% and a national average of 28.1%.

What This Means if You're Moving to Rose Bud

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from Cahollandrd and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 36% of Rose Bud is under tree cover (about average for cities), and the dominant land cover is pasture / hay. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.