This map shows modeled outdoor noise across Conesus at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.
What the numbers sound like
- 30 dBAWhisper
- 40 dBASoft rainfall
- 45 dBAQuiet suburban street at night
- 50 dBAQuiet office
- 55 dBAEPA outdoor threshold: light traffic 100 ft away
- 60 dBANormal conversation an arm's length away
- 65 dBABusy restaurant
- 70 dBAHighway traffic 50 ft away
- 80 dBACity bus interior
Population Above the EPA Outdoor Threshold
The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 122 Conesus residents, or 5.3%, live above that level. By land area, 4.8% of Conesus is above 55 dBA.
See how noise in Conesus compares to similar-sized cities.
Noise by Part of Conesus
Average noise levels for Conesus residents, grouped by direction from the center of Conesus. The highest population-weighted average is in northwestern Conesus; the lowest is in southeastern Conesus, where just 1% of residents live in blocks above the EPA's 55 dBA threshold, about half the share in the loudest section.
Northwestern Conesus
2% of people above 55 dBA
Northern Conesus
2% of people above 55 dBA
Western Conesus
2% of people above 55 dBA
Southern Conesus
1% of people above 55 dBA
Southeastern Conesus
1% of people above 55 dBA
To the human ear, noise in northwestern Conesus sounds about 23% louder than in southeastern Conesus, a 3.0 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.
How Noise Is Distributed Across Conesus
The bar chart below shows the share of Conesus residents in each noise band. About 99% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.
How Conesus Compares
Conesus sits at the louder end of the spectrum. Below: how Conesus's average outdoor noise and share of residents above the EPA threshold compare with Springwater, Honeoye, Nunda, and Hemlock.
Average noise level (dBA)
Conesus's 43.6 dBA pop-weighted average is at the louder end of the spectrum. New York as a whole averages 55.4 dBA and the U.S. averages 52.0 dBA. Both are lower than Conesus because most of either area is rural land away from major roads.
Share of residents above 55 dBA
About 5.3% of Conesus residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's in the middle of its peer group. Measured by land area instead, 4.8% of Conesus's footprint sits above 55 dBA, against a New York average of 30.9% and a national average of 28.1%.
What This Means if You're Moving to Conesus
- Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from Sliker Hill Rd and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
- Tree canopy can help reduce modeled noise exposure. Roughly 51% of Conesus is under tree cover (heavier than most cities), and the dominant land cover is deciduous forest. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.
Sources & Methodology
The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.
Federal datasets used:
FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level
All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.