Noise Levels in Federal Dam, MN | Find Quiet Neighborhoods With Our Sound Map

46 dBA
Average noise across Federal Dam
Quiet office
50
Residents above the EPA 55 dBA threshold
13% of Federal Dam residents
63 dBA
Loudest residential point
Busy restaurant

This map shows modeled outdoor noise across Federal Dam at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Federal Dam, MN Map of Noise Levels in Federal Dam
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 50 Federal Dam residents, or 13.3%, live above that level. By land area, 25.1% of Federal Dam is above 55 dBA.

See how noise in Federal Dam compares to similar-sized cities.

Noise by Part of Federal Dam

Average noise levels for Federal Dam residents, grouped by direction from the center of Federal Dam. Eastern Federal Dam carries the highest population-weighted average; Northern Federal Dam carries the lowest. Just 6% of residents in Northern Federal Dam live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Eastern Federal Dam.

Eastern Federal Dam

48.6 dBA · Mostly quiet
Quiet office

30% of people above 55 dBA

QuietLoud

Northern Federal Dam

43.6 dBA · Quiet
Quiet suburban street at night

6% of people above 55 dBA

QuietLoud

Southern Federal Dam

44.4 dBA · Quiet
Quiet suburban street at night

4% of people above 55 dBA

QuietLoud

Western Federal Dam

46.0 dBA · Mostly quiet
Quiet suburban street at night

5% of people above 55 dBA

QuietLoud

Eastern Federal Dam sounds about 41% louder than Northern Federal Dam to the human ear, a 5.0 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

Loudest Road Corridors

The model evaluates every road in Federal Dam using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance, faster in vegetated areas and slower over open pavement.

RoadTypeAvg. source dBAPeak source dBA
Sugar Point Dr NW Local 55.0 55
16TH Ave NE Local 55.0 55
Main St Local 55.0 55
Battle Point Dr NW Local 55.0 55
Black Duck Point Dr NE Local 55.0 55

How far back from Sugar Point Dr NW do you need to be?

Sugar Point Dr NW produces an estimated 55 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
55 dBA
Quiet office to normal conversation
165 ft
43 dBA
Quiet suburban street at night
330 ft
36 dBA
Soft rainfall
660 ft
35 dBA
Soft rainfall
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 35% of Federal Dam sits under tree canopy (about average for cities) and roughly 3% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

How Noise Is Distributed Across Federal Dam

The bar chart below shows the share of Federal Dam residents in each noise band. About 89% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Federal Dam Compares

Federal Dam sits at the louder end of the spectrum. Below: how Federal Dam's average outdoor noise and share of residents above the EPA threshold compare with Boy River, Inguadona, Ball Club, and Bena.

Average noise level (dBA)

Federal Dam's 46.2 dBA pop-weighted average is at the louder end of the spectrum. Minnesota as a whole averages 53.6 dBA and the U.S. averages 52.0 dBA. Both are lower than Federal Dam because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 13.3% of Federal Dam residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's in the middle of its peer group. Measured by land area instead, 25.1% of Federal Dam's footprint sits above 55 dBA, against a Minnesota average of 31.0% and a national average of 28.1%.

What This Means if You're Moving to Federal Dam

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from Sugar Point Dr NW and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 35% of Federal Dam is under tree cover (about average for cities), and the dominant land cover is deciduous forest. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.