Noise Levels in Kingsmill, TX | Find Quiet Neighborhoods With Our Sound Map
40 dBA
Average noise across Kingsmill
Soft rainfall
4
Residents above the EPA 55 dBA threshold
2% of Kingsmill residents
88 dBA
Loudest residential point
Lawnmower at 1 m
This map shows modeled outdoor noise across Kingsmill at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.
What the numbers sound like
- 30 dBAWhisper
- 40 dBASoft rainfall
- 45 dBAQuiet suburban street at night
- 50 dBAQuiet office
- 55 dBAEPA outdoor threshold: light traffic 100 ft away
- 60 dBANormal conversation an arm's length away
- 65 dBABusy restaurant
- 70 dBAHighway traffic 50 ft away
- 80 dBACity bus interior
Population Above the EPA Outdoor Threshold
The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 4 Kingsmill residents, or 2.2%, live above that level. By land area, 13.4% of Kingsmill is above 55 dBA.
86.6% below 55 dBA
13.4% above 55 dBA
See how noise in Kingsmill compares to similar-sized cities.
Noise by Part of Kingsmill
Average noise levels for Kingsmill residents, grouped by direction from the center of Kingsmill. Western Kingsmill carries the highest population-weighted average; Southern Kingsmill carries the lowest. Just 0% of residents in Southern Kingsmill live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Western Kingsmill.
Eastern Kingsmill
39.5 dBA · Quiet
Soft rainfall
Northern Kingsmill
41.0 dBA · Quiet
Soft rainfall
Southern Kingsmill
35.3 dBA · Quiet
Soft rainfall
Western Kingsmill
43.8 dBA · Quiet
Quiet suburban street at night
Western Kingsmill sounds about 80% louder than Southern Kingsmill to the human ear, a 8.5 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.
How far back from do you need to be?
produces an estimated 88 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a quiet office to normal conversation.
At source
88 dBA
Lawnmower at 1 m
165 ft
75 dBA
City bus interior
330 ft
67 dBA
Highway traffic 50 ft away
660 ft
60 dBA
Normal conversation an arm’s length away
¼ mile
52 dBA
Quiet office to normal conversation
½ mile
44 dBA
Quiet suburban street at night
Calculated from the model's calibrated attenuation formula. About 0% of Kingsmill sits under tree canopy (much lighter than most cities) and roughly 1% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.
-->
Rail Noise
Active freight rail runs through parts of Kingsmill. For most blocks the rail-only contribution is small. Combined road-plus-rail noise rarely exceeds road noise on its own. The exceptions are the handful of blocks within roughly a quarter mile of the right-of-way during pass-through hours.
Use the Rail toggle on the map above to isolate rail's contribution from road and aviation.
How Noise Is Distributed Across Kingsmill
The bar chart below shows the share of Kingsmill residents in each noise band. About 97% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.
How Kingsmill Compares
Kingsmill sits at the quieter end of the spectrum. Below: how Kingsmill's average outdoor noise and share of residents above the EPA threshold compare with Skellytown, Lefors, Sanford, and Bunavista.
Average noise level (dBA)
Kingsmill's 40.2 dBA pop-weighted average is at the quieter end of the spectrum. Texas as a whole averages 50.8 dBA and the U.S. averages 52.0 dBA. Both are lower than Kingsmill because most of either area is rural land away from major roads.
Share of residents above 55 dBA
About 2.2% of Kingsmill residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's in the middle of its peer group. Measured by land area instead, 13.4% of Kingsmill's footprint sits above 55 dBA, against a Texas average of 22.8% and a national average of 28.1%.
What This Means if You're Moving to Kingsmill
- Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
- Tree canopy can help reduce modeled noise exposure. Roughly 0% of Kingsmill is under tree cover (much lighter than most cities), and the dominant land cover is grassland. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.
