Noise Levels in Sun River, MT | Find Quiet Neighborhoods With Our Sound Map

37 dBA
Average noise across Sun River
Soft rainfall
8
Residents above the EPA 55 dBA threshold
2% of Sun River residents
63 dBA
Loudest residential point
Busy restaurant

This map shows modeled outdoor noise across Sun River at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Sun River, MT Map of Noise Levels in Sun River
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 8 Sun River residents, or 2.1%, live above that level. By land area, 2.4% of Sun River is above 55 dBA.

See how noise in Sun River compares to similar-sized cities.

Noise by Part of Sun River

Average noise levels for Sun River residents, grouped by direction from the center of Sun River. Eastern Sun River carries the highest population-weighted average; Southern Sun River carries the lowest. Just 0% of residents in Southern Sun River live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Eastern Sun River.

Eastern Sun River

42.7 dBA · Quiet
Quiet suburban street at night

4% of people above 55 dBA

QuietLoud

Northern Sun River

41.4 dBA · Quiet
Quiet suburban street at night

2% of people above 55 dBA

QuietLoud

Southern Sun River

28.1 dBA · Quiet
Whisper

0% of people above 55 dBA

QuietLoud

Western Sun River

37.8 dBA · Quiet
Soft rainfall

3% of people above 55 dBA

QuietLoud

Eastern Sun River sounds about 175% louder than Southern Sun River to the human ear, a 14.6 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

Loudest Road Corridors

The model evaluates every road in Sun River using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance, faster in vegetated areas and slower over open pavement.

RoadTypeAvg. source dBAPeak source dBA
So Birdtail Rd Local 51.0 51
Parker Rd Local 51.0 51
Knapstad Rd Local 51.0 51
Shaw Cutoff Rd Local 51.0 51
Little Muddy Rd Local 51.0 51

How far back from So Birdtail Rd do you need to be?

So Birdtail Rd produces an estimated 51 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
51 dBA
Quiet office
165 ft
38 dBA
Soft rainfall
330 ft
35 dBA
Soft rainfall
660 ft
35 dBA
Soft rainfall
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 3% of Sun River sits under tree canopy (much lighter than most cities) and roughly 2% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

How Noise Is Distributed Across Sun River

The bar chart below shows the share of Sun River residents in each noise band. About 98% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Sun River Compares

Sun River sits at the quieter end of the spectrum. Below: how Sun River's average outdoor noise and share of residents above the EPA threshold compare with Simms, Power, Golden Ridge, and Greenfield.

Average noise level (dBA)

Sun River's 37.4 dBA pop-weighted average is at the quieter end of the spectrum. Montana as a whole averages 49.0 dBA and the U.S. averages 52.0 dBA. Both are lower than Sun River because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 2.1% of Sun River residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's more than any of its peer group. Measured by land area instead, 2.4% of Sun River's footprint sits above 55 dBA, against a Montana average of 16.9% and a national average of 28.1%.

What This Means if You're Moving to Sun River

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from So Birdtail Rd and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 3% of Sun River is under tree cover (much lighter than most cities), and the dominant land cover is grassland. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.