Noise Levels in Willits, CA | Find Quiet Neighborhoods With Our Sound Map

48 dBA
Average noise across Willits
Quiet office
1,409
Residents above the EPA 55 dBA threshold
14% of Willits residents
71 dBA
Loudest residential point
Highway traffic 50 ft away

This map shows modeled outdoor noise across Willits at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Willits, CA Map of Noise Levels in Willits
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 1,409 Willits residents, or 13.5%, live above that level. By land area, 15.8% of Willits is above 55 dBA.

See how noise in Willits compares to similar-sized cities.

Noise by Part of Willits

Average noise levels for Willits residents, grouped by direction from the center of Willits. Southern Willits carries the highest population-weighted average; Central Willits carries the lowest. Just 0% of residents in Central Willits live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Southern Willits.

Central Willits

36.0 dBA · Quiet
Soft rainfall

0% of people above 55 dBA

QuietLoud

Eastern Willits

43.0 dBA · Quiet
Quiet suburban street at night

5% of people above 55 dBA

QuietLoud

Northern Willits

46.1 dBA · Mostly quiet
Quiet office

11% of people above 55 dBA

QuietLoud

Southern Willits

49.5 dBA · Mostly quiet
Quiet office

18% of people above 55 dBA

QuietLoud

Western Willits

48.4 dBA · Mostly quiet
Quiet office

9% of people above 55 dBA

QuietLoud

Southern Willits sounds about 155% louder than Central Willits to the human ear, a 13.5 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

How far back from do you need to be?

produces an estimated 71 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
71 dBA
Highway traffic 50 ft away
165 ft
59 dBA
Normal conversation an arm’s length away
330 ft
52 dBA
Quiet office to normal conversation
660 ft
46 dBA
Quiet suburban street at night
¼ mile
39 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 37% of Willits sits under tree canopy (about average for cities) and roughly 23% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

-->

How Noise Is Distributed Across Willits

The bar chart below shows the share of Willits residents in each noise band. About 92% of residents live below the EPA's 55 dBA threshold, and roughly 0% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Willits Compares

Willits sits the highest among the peer group. Below: how Willits's average outdoor noise and share of residents above the EPA threshold compare with Fort Bragg, Redwood Valley, Lakeport, and Kelseyville.

Average noise level (dBA)

Willits's 47.8 dBA pop-weighted average is the highest among the peer group. California as a whole averages 54.0 dBA and the U.S. averages 52.0 dBA. Both are lower than Willits because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 13.5% of Willits residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's in the middle of its peer group. Measured by land area instead, 15.8% of Willits's footprint sits above 55 dBA, against a California average of 36.0% and a national average of 28.1%.

What This Means if You're Moving to Willits

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 37% of Willits is under tree cover (about average for cities), and the dominant land cover is evergreen forest. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.