Noise Levels in Woolcott, KY | Find Quiet Neighborhoods With Our Sound Map

55 dBA
Average noise across Woolcott
Quiet office to normal conversation
11
Residents above the EPA 55 dBA threshold
33% of Woolcott residents
67 dBA
Loudest residential point
Highway traffic 50 ft away

This map shows modeled outdoor noise across Woolcott at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.

Overall
Road
Rail
Aviation
Woolcott, KY Map of Noise Levels in Woolcott
Click the map to explore
35 45 55 70 90
Quietest (dBA) Loudest
Colorblind friendly off

What the numbers sound like

  • 30 dBAWhisper
  • 40 dBASoft rainfall
  • 45 dBAQuiet suburban street at night
  • 50 dBAQuiet office
  • 55 dBAEPA outdoor threshold: light traffic 100 ft away
  • 60 dBANormal conversation an arm's length away
  • 65 dBABusy restaurant
  • 70 dBAHighway traffic 50 ft away
  • 80 dBACity bus interior

Population Above the EPA Outdoor Threshold

The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 11 Woolcott residents, or 32.8%, live above that level. By land area, 24.4% of Woolcott is above 55 dBA.

See how noise in Woolcott compares to similar-sized cities.

Noise by Part of Woolcott

Average noise levels for Woolcott residents, grouped by direction from the center of Woolcott. Eastern Woolcott carries the highest population-weighted average; Western Woolcott carries the lowest. Just 5% of residents in Western Woolcott live in blocks above the EPA's 55 dBA threshold, a fifth of the share in Eastern Woolcott.

Central Woolcott

54.0 dBA · Moderate-loud
Quiet office to normal conversation

14% of people above 55 dBA

QuietLoud

Eastern Woolcott

62.9 dBA · Loud
Busy restaurant

100% of people above 55 dBA

QuietLoud

Northern Woolcott

52.7 dBA · Moderate
Quiet office to normal conversation

13% of people above 55 dBA

QuietLoud

Western Woolcott

49.3 dBA · Mostly quiet
Quiet office

5% of people above 55 dBA

QuietLoud

Eastern Woolcott sounds about 157% louder than Western Woolcott to the human ear, a 13.6 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.

How far back from North Aa Hwy do you need to be?

North Aa Hwy produces an estimated 63 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.

At source
63 dBA
Busy restaurant
165 ft
51 dBA
Quiet office
330 ft
44 dBA
Quiet suburban street at night
660 ft
36 dBA
Soft rainfall
¼ mile
35 dBA
Soft rainfall
½ mile
35 dBA
Soft rainfall

Calculated from the model's calibrated attenuation formula. About 69% of Woolcott sits under tree canopy (much heavier than most cities) and roughly 5% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.

-->

How Noise Is Distributed Across Woolcott

The bar chart below shows the share of Woolcott residents in each noise band. About 56% of residents live below the EPA's 55 dBA threshold, and roughly 24% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.

How Woolcott Compares

Woolcott sits the highest among the peer group. Below: how Woolcott's average outdoor noise and share of residents above the EPA threshold compare with Willow Grove, Ivor, Gubser Mill, and Washington.

Average noise level (dBA)

Woolcott's 55.2 dBA pop-weighted average is the highest among the peer group. Kentucky as a whole averages 50.5 dBA and the U.S. averages 52.0 dBA. Both are lower than Woolcott because most of either area is rural land away from major roads.

Share of residents above 55 dBA

About 32.8% of Woolcott residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's more than any of its peer group. Measured by land area instead, 24.4% of Woolcott's footprint sits above 55 dBA, against a Kentucky average of 23.2% and a national average of 28.1%.

What This Means if You're Moving to Woolcott

  • Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from North Aa Hwy and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
  • Tree canopy can help reduce modeled noise exposure. Roughly 69% of Woolcott is under tree cover (much heavier than most cities), and the dominant land cover is deciduous forest. Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.

Sources & Methodology

The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.

Federal datasets used:

FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level

All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.