This map shows modeled outdoor noise across Beaverhead County at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.
What the numbers sound like
- 30 dBAWhisper
- 40 dBASoft rainfall
- 45 dBAQuiet suburban street at night
- 50 dBAQuiet office
- 55 dBAEPA outdoor threshold: light traffic 100 ft away
- 60 dBANormal conversation an arm's length away
- 65 dBABusy restaurant
- 70 dBAHighway traffic 50 ft away
- 80 dBACity bus interior
Population Above the EPA Outdoor Threshold
The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 303 Beaverhead County residents, or 4.1%, live above that level. By land area, 7.5% of Beaverhead County is above 55 dBA.
See how noise in Beaverhead County compares to similar-sized counties.
Noise by Part of Beaverhead County
Average noise levels for Beaverhead County residents, grouped by direction from the center of Beaverhead County. The highest population-weighted average is in the Dillon area (eastern Beaverhead County); the lowest is in northwestern Beaverhead County, where just 0% of residents live in blocks above the EPA's 55 dBA threshold, a fifth of the share in the loudest section.
Dillon
11% of people above 55 dBA
Northeastern Beaverhead County
3% of people above 55 dBA
Southern Beaverhead County
0% of people above 55 dBA
Western Beaverhead County
0% of people above 55 dBA
Northwestern Beaverhead County
0% of people above 55 dBA
To the human ear, noise in the Dillon area (eastern Beaverhead County) sounds about 197% louder than in northwestern Beaverhead County, a 15.7 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.
Loudest Road Corridors
The model evaluates every road in Beaverhead County using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance from there.
How far back from I-15 do you need to be?
I-15 produces an estimated 72 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a soft rainfall.
Calculated from the model's distance-decay formula. Where federal land-cover data reaches, the decay rate is set from the place's tree canopy, pavement and land cover. The map above uses one standard rate everywhere.
Rail Noise
Rail lines run through or near parts of Beaverhead County. The U.S. Department of Transportation's National Transportation Noise Map models their noise, and the figures on this page add it to road and aviation noise.
Use the Rail toggle on the map above to isolate rail's contribution from road and aviation.
How Noise Is Distributed Across Beaverhead County
The bar chart below shows the share of Beaverhead County residents in each noise band. About 95% of residents live below the EPA's 55 dBA threshold, and roughly 1% live in blocks above 60 dBA. A systematic review for the World Health Organization's 2018 Environmental Noise Guidelines found that the risk of ischemic heart disease rises about 8% for every 10 dB increase in long-term road traffic noise.
How Beaverhead County Compares
Beaverhead County sits at the quieter end of the spectrum. Below: how Beaverhead County's average outdoor noise and share of residents above the EPA threshold compare with Madison County, Deer Lodge County, Jefferson County, and Silver Bow County.
Average noise level (dBA)
Beaverhead County's 43.7 dBA pop-weighted average is at the quieter end of the spectrum. Montana as a whole averages 49.0 dBA, and the U.S. averages 52.0 dBA.
Share of residents above 55 dBA
About 4.1% of Beaverhead County residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's in the middle of its peer group. Measured by land area instead, 7.5% of Beaverhead County's footprint sits above 55 dBA, against a Montana average of 16.9% and a national average of 28.1%.
What This Means if You're Moving to Beaverhead County
- Distance from major roads matters more than the neighborhood name. Two homes in the same ZIP code can differ by more than 15 dBA when one sits 100 meters from a highway and the other 500 meters away. The model works at 100-meter resolution, so noise exposure changes block by block.
- Land cover sets how fast noise fades in the model. About 2% of Beaverhead County is under tree canopy, much lighter than most counties, and about 24% is impervious surface such as pavement and rooftops. Its most common land cover is low-intensity developed land. These figures come from USDA Forest Service and USGS satellite data at 30-meter resolution, and the model uses them to set the rate at which noise fades with distance in Beaverhead County.
Sources & Methodology
The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.
Federal datasets used:
FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level
Health research cited:
World Health Organization Environmental Noise Guidelines systematic review (2018): road traffic noise and heart disease
All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.