This map shows modeled outdoor noise across Honolulu County at 100-meter resolution, combining road, aviation, and rail sources. Green areas measure below 45 dBA. Orange and red exceed the EPA's 55 dBA outdoor threshold linked to long-term health effects. Use the layer toggles to view each source on its own or all together.
What the numbers sound like
- 30 dBAWhisper
- 40 dBASoft rainfall
- 45 dBAQuiet suburban street at night
- 50 dBAQuiet office
- 55 dBAEPA outdoor threshold: light traffic 100 ft away
- 60 dBANormal conversation an arm's length away
- 65 dBABusy restaurant
- 70 dBAHighway traffic 50 ft away
- 80 dBACity bus interior
Population Above the EPA Outdoor Threshold
The EPA's 55 dBA outdoor reference level is a common benchmark for residential noise exposure, especially for activity interference, annoyance, and long-term community noise concerns. About 418,370 Honolulu County residents, or 47.0%, live above that level. By land area, 48.7% of Honolulu County is above 55 dBA.
See how noise in Honolulu County compares to similar-sized counties.
Noise by Part of Honolulu County
Average noise levels for Honolulu County residents, grouped by direction from the center of Honolulu County. Central Honolulu County carries the highest population-weighted average; Northern Honolulu County carries the lowest. Just 30% of residents in Northern Honolulu County live in blocks above the EPA's 55 dBA threshold, about half the share in Central Honolulu County.
Central Honolulu County
80% of people above 55 dBA
Eastern Honolulu County
48% of people above 55 dBA
Northern Honolulu County
30% of people above 55 dBA
Southern Honolulu County
67% of people above 55 dBA
Western Honolulu County
43% of people above 55 dBA
Central Honolulu County sounds about 96% louder than Northern Honolulu County to the human ear, a 9.7 dBA gap. Every 10 dBA roughly doubles perceived loudness. Within any of these directions, two homes a quarter mile apart can still differ by 10 or more dBA depending on how close they sit to a major highway.
Loudest Road Corridors
The model evaluates every road in Honolulu County using federal traffic counts, posted speeds, heavy-truck ratios, and pavement type. The source level shown is the modeled noise at the road centerline, where it is loudest. Noise drops with distance, faster in vegetated areas and slower over open pavement.
How far back from H-1 do you need to be?
H-1 produces an estimated 79 dBA at its loudest centerline points. Noise drops logarithmically with distance, with the exact rate depending on what's between you and the road. Tree cover, walls, terrain, and pavement type all matter. At roughly a quarter mile back, traffic fades into the noise level of a quiet suburban street at night.
Calculated from the model's calibrated attenuation formula. About 0% of Honolulu County sits under tree canopy (about average for counties) and roughly 0% is impervious surface like pavement and rooftops. Both are folded into the per-place decay rate above. Heavier canopy pulls noise down faster with distance; impervious surfaces slow the drop.
Airport Noise
Daniel K Inouye International (HNL) sits south of Honolulu County. The U.S. Department of Transportation measures aviation noise around this airport directly, and the model uses those federal measurements rather than synthetic predictions.
Blocks under the approach and departure paths carry combined road-plus-aviation noise, with some exceeding 95 dBA on the map's Overall layer. Blocks on the opposite side of Honolulu County, particularly to the north, show no measurable aviation contribution. Use the Aviation toggle on the map above to isolate the airport's footprint.
How Noise Is Distributed Across Honolulu County
The bar chart below shows the share of Honolulu County residents in each noise band. About 42% of residents live below the EPA's 55 dBA threshold, and roughly 28% live in blocks above 60 dBA. Long-term exposure in that range is linked to elevated stress hormones and cardiovascular risk.
How Honolulu County Compares
Honolulu County sits the highest among the peer group. Below: how Honolulu County's average outdoor noise and share of residents above the EPA threshold compare with Maui County, Kauai County, Hawaii County, and Kalawao County.
Average noise level (dBA)
Honolulu County's 56.8 dBA pop-weighted average is the highest among the peer group. Hawaii as a whole averages 54.8 dBA and the U.S. averages 52.0 dBA. Both are lower than Honolulu County because most of either area is rural land away from major roads.
Share of residents above 55 dBA
About 47.0% of Honolulu County residents live in blocks where outdoor levels exceed the EPA's 55 dBA threshold. That's more than any of its peer group. Measured by land area instead, 48.7% of Honolulu County's footprint sits above 55 dBA, against a Hawaii average of 34.4% and a national average of 28.1%.
What This Means if You're Moving to Honolulu County
- Distance from highways matters more than the neighborhood name. Two homes in the same zip code can differ by 20 dBA if one sits 100 meters from H-1 and the other 500 meters away. The model captures this at 100-meter resolution, so noise exposure changes block by block.
- Tree canopy can help reduce modeled noise exposure. Roughly 0% of Honolulu County is under tree cover (about average for counties), and the dominant land cover is . Both are measured from federal USDA Forest Service and USGS satellite imagery at 30-meter resolution. Streets with 60% or higher canopy show 3 to 5 dBA lower noise than comparable streets with bare ground or pavement, which is why the per-place decay rate above already accounts for it.
- Airport noise is directional. Daniel K Inouye International's approach paths concentrate aviation noise to the south. Neighborhoods to the north of downtown show no measurable contribution from the airport.
Sources & Methodology
The BestNeighborhood noise model is calibrated against nearly one million federal ground-truth measurements across four states. Road noise is computed from segment-level federal traffic data and propagated outward using physics-based acoustic decay, with attenuation rates that depend on the surrounding land cover.
Federal datasets used:
FHWA Highway Performance Monitoring System: road geometry, traffic counts, lane configuration
U.S. DoT Bureau of Transportation Statistics National Transportation Noise Map: aviation and rail noise, road calibration ground truth
USGS / MRLC National Land Cover Database: land cover and impervious surface coverage
USDA Forest Service Tree Canopy Cover: vegetation density for sound propagation
U.S. Census Bureau TIGER/Line: block-level geography and population
U.S. EPA Levels Document: 55 dBA outdoor reference level
All inputs are published federal datasets. Block-level noise is computed by combining road, rail, and aviation sound sources in the energy domain, the same physics used in professional environmental noise assessments. Read the full methodology.